Tech Tips

Installing Front Disc Brake Conversion, TD & TF

Installing Front Disc Brake Conversion, TD & TF

Here are some photos of how easy it is to install the front disc brake conversion on an MG TD or TF. Please carefully follow the directions include with the kit. (Working on cars can be hazardous, when modifying a car's...

Read now
Installing LED Headlights, MG TD

Installing LED Headlights, MG TD

We now offer LED headlights, a direct replacement for the 7" sealed beam headlights found in TDs, TFs and MGBs. These really are a plug and play installation, very well constructed and fit as original, with the standard 3 prong...

Read now
Installing LED Headlights, MGB

Installing LED Headlights, MGB

We now offer LED headlights, a direct replacement for the 7" sealed beam headlights found in TDs, TFs and MGBs. These really are a plug and play installation, very well constructed and fit as original, with the standard 3 prong...

Read now
Dynamator - Vintage look Alternator for T-Types!

Dynamator - Vintage look Alternator for T-Types!

  The DYNAMATOR is an Authentic looking Dynamo that in fact is a high output 45Amp Alternator, giving a considerable increase on performance, with the added advantage of being light weight, weighing in at less than 8 lbs, as compared...

Read now
No Spark? Testing your classic car ignition system

No Spark? Testing your classic car ignition system

Here is a link to an article from Classic Motorsports showing a step by step testing procedure for the typical ignition system found in our classic cars. The article provides a very logical approach giving a very good explanation of how...

Read now
MG T-Type Spark Plugs, 1/2" or 3/4"?

MG T-Type Spark Plugs, 1/2" or 3/4"?

A common question we get asked a lot is how do I know if my MG T-Type engine should use 1/2" or 3/4" spark plugs. Common knowledge says that it is based on engine numbers, cars with engine numbers lower...

Read now
T-Type Spark Plug Wire setup

T-Type Spark Plug Wire setup

The T-Type workshop manual has a good description of how to make and install a set of ignition wires. Our ignition wire sets have the wire in one piece, easily enough to make a complete set of wires for an...

Read now
Installing LED Tail Lamp Boards, Early TD

Installing LED Tail Lamp Boards, Early TD

The LED board for the early TD tail lamp is installed in place of the original metal socket, directly to the metal socket support plate. Refer to the wiring instructions included with the LED set for connection details. Here are...

Read now
Installing LED Tail Lamp Boards, late TD and TF

Installing LED Tail Lamp Boards, late TD and TF

The LED board for the late TD and TF tail lamp is installed in place of the original metal socket, directly to the chrome plinth through the rubber body. Refer to the wiring instructions included with the LED set for...

Read now
Sealing up a Fuel Sender

Sealing up a Fuel Sender

The fuel tank sender can often be the source of unwanted fuel leaks in the T- series cars. There can be a number of reasons for these leaks, most common ones are due to the failure of the sealing gaskets...

Read now
King Pin Seals installation

King Pin Seals installation

We get many inquiries about how the swivel link seals are installed. Here are a few photos of how it all goes together. I used a TD kingpin without the steering arm and spindle, easier to take photos. This is...

Read now